Cone - Square and Round

I can do that. Will be in the next pre-release

Thanks very much!

Hey Scott — this is done and will land in the next pre-release.

It ended up as a single Cone (Square & Round) shape in the Shape Generator (Fabrication category) that spits out a ready-to-cut flat pattern, with a couple of options based on how you like to build:

• Rolled (round) — one blank you roll into a smooth cone.
• Segmented (flat-sided) — straight panels; you pick the number of sides, and 4 sides gives you a square cone. Emit it as separate panels to weld/rivet edge-to-edge, or as one connected strip with fold lines for bending on a brake.

Other bits you get:

• Cone or frustum — enter a bottom and top diameter (set the top to 0 for a point cone), plus a height.
• Weld or pop-rivet — a plain butt seam, or a lap seam that adds overlap material for riveting.
• Rivet holes that line up — a row of evenly spaced fastener holes along the seam, mirrored on both mating edges so they register perfectly once it's rolled up.
• Optional seam centerline, fold lines, and center/quadrant reference marks to help while rolling.

Thanks for the request!