125a Hypertherm missing from list

Hello Alan,

Good idea, I'll have that ready soon!

Hi Alan,

Good news — the Hypertherm Powermax 125 is now built in. When you set up a plasma machine you'll be able to pick Hypertherm → Powermax 125, and it loads the factory cut charts across the machine's full range — 125, 105, 65 and 45 amp shielded, plus FineCut — for mild steel, stainless and aluminum, with the book's speeds, voltages, pierce settings and kerf widths ready to go. As with the other cutters, you can clone any chart into your own profile to fine-tune it for your table.

This will land in the next release. Thanks for the request, and for the manual link — it made getting the numbers right easy.

Thanks,
Travis