Learn/Waterjet/Toolpaths & Posting
Mach3 & Mach4 File Posts
At a glance
- Post a .tap file for Mach3 or Mach4.
- Set valve M-codes, optional P output numbers, and dwell timing for the shop’s controller profile.
- Simulate the flat-sheet toolpath before saving the machine program.
Select Mach3 Waterjet or Mach4 Waterjet in the machine's Post Processor settings. Both posts default to M3 for water on and M5 for water off. Confirm those commands match the controller profile. For abrasive jobs, enter the commands your controller profile assigns to abrasive on and off. If a valve command takes a numbered output, include it in the same field, such as M101 P1 for a shop macro configured that way. The post includes the P number in the file.
The program moves to the cut start, opens the water valve and waits for the chart's water-start delay. An abrasive job then enables abrasive and waits for its start delay. The stationary pierce dwell follows, then the cut. At the end of each cut span, the post turns off abrasive, waits for the chart's abrasive-stop delay, turns off water, and waits for its water-stop delay before travel. Water Only uses the water valve throughout.
For Mach3, match the post's G04 dwell in ms option to the controller’s setting. The Mach4 post uses seconds. Keep the program in the units selected on the machine profile. With Programmed Z, set work zero so the chart's cut and clearance heights correspond to the stock.
For a programmed pressure or abrasive flow, map an M-code with a single argument such as M100 P{value}. The post inserts the pressure in psi or flow in lb/min. The M-code and value convention must match the controller's macro. Use Simulation to check the cutting path, then Post Process to save the file for your controller.
Verify machine-specific valve and macro behavior on your controller. See Machine, Media & Cut Charts for the chart fields used by the post.