STEP Plate Bevels
At a glance
- Import supported .step and .stp plate solids directly into Plasma
- Send an exact Drafting body to Plasma without exporting a separate file
- Confirm orientation, dimensions, thickness, chamfers, and lands before import
- Cut modeled top chamfers first, then the vertical outline that releases the part
- See the true solid and run the full five-axis sequence in motion simulation
- Simulation-only in v2.6.1 — physical output is disabled for this new job type
Import a plate as a solid when its modeled chamfers matter to the cutting sequence. Select a
bevel-capable Plasma machine profile first. The Parts browser then shows STEP Plate… under the
+ From File dropdown, and + From Drafting opens a picker for modeled bodies. You can also
drag a .step / .stp file onto Plasma or use Send To Plasma… from a Drafting body. JetCad3
reads the actual solid instead of flattening its top outline.
Confirm the solid before adding it
The import dialog shows the detected top, overall width and height, stock thickness, chamfer angles, chamfer depths and remaining lands. Review that evidence before accepting the part. If the active sheet already contains parts and its thickness does not match the solid, the import stops instead of changing the sheet behind the existing job.
The accepted part keeps a geometric snapshot inside the project, so save/reopen and regeneration do not depend on the original STEP file.
Supported plate geometry
This first release accepts a conservative plate shape:
- two parallel broad faces and one constant stock thickness
- vertical outside walls and vertical through-holes
- straight planar chamfers along the top edges
- a measurable vertical land below every chamfer
JetCad3 rejects bottom bevels, curved or variable-angle chamfers, fillets that resemble chamfers, blind pockets, non-plate solids and unresolved shapes. A rejected solid stays out of the CAM document; it is never silently converted into a flat profile.
Toolpath order and simulation
Generate creates one finite pass for each modeled chamfer, then the vertical outside cut that releases the part. The torch pierces upright in scrap, reaches full tilt before the finished edge, continues through the stock into scrap with height control off, leaves the edge, and squares before the next rapid. Holes remain ahead of the final outside release.
The 3D view shows the actual broad faces, chamfer faces and vertical lands. Chamfer toolpaths have a different color from the final release cut. Press Play to run the sequence through the same JetFlight motion simulator used by the rest of Plasma; Stop uses the normal simulator control.
Placement and current limits
Move, rotate, mirror and duplicate accepted parts normally. JetCad3 checks the complete tilted-jet envelope against the sheet, machine travel and neighboring parts. Place these parts manually in v2.6.1: Auto Nest, Common Grid, Fill Sheet and Grid Array are unavailable. Scale and Simplify are also unavailable because they would change the accepted solid.
Tabs, marking, Pre-Pierce All and unverified contour overrides cannot be combined with this new part type. Those limits apply only to solid-derived bevel plates.
Simulation-only qualification
v2.6.1 supports import, generated toolpaths and real motion simulation for these STEP plate bevels. Physical posting is disabled whenever a job contains a solid-derived multi-pass bevel operation, so the job cannot produce a production file yet. Ordinary three-axis Plasma parts, DXF/SVG import and the existing manual contour Bevel… workflow keep their previous behavior.
See Cut Simulation for the transport controls and Import from Drafting Workspace for linked sketch imports.