Mirror / Flip Part
At a glance
- Select an unlocked part, then use the Mir X or Mir Y checkbox below the viewport toolbar
- Mirror parts left to right with Mir X or top to bottom with Mir Y
- Flip a part for cutting diamond tread plate face down and keep the original DXF
Flip an imported part on the sheet
- Click the part in the Plasma viewport. If it is locked, unlock it in the Parts browser and select it again.
- Look below the viewport toolbar for the transform strip next to the X, Y, and Rot ° fields. Check Mir X to flip left to right or Mir Y to flip top to bottom. Use one checkbox for a mirror image. Clear it to restore that axis.
- Check the mirrored outline and hole positions in the top-down view, then place or nest the part. Regenerate the toolpaths before posting.
Cut diamond tread plate face down
If you drew an asymmetric part from the tread side but plan to cut with the smooth side up, mirror the imported part in Plasma. Pick the checkbox that matches how you will turn the plate over and check a distinctive corner or hole in the preview. The mirror applies to the part in your CAM job. Your source DXF stays intact.
The same Mir X and Mir Y controls are available in Oxyfuel, Laser, and Router. For placement and rotation, see Sheet & Part Layout.